Lone Star Suds Directions for Use

For best results, shake well before each use. These are truly blended products that will separate over time, so keep them mixed!

First time use - Unscrew the black dispensing cap and remove the RED shipping plug from the bottle. It fits pretty tight and may be a little difficult to remove. Replace the black dispensing cap.

For Bucket Washing - squeeze 1 to 2 ounces of Lone Star Suds into an empty 5 gallon clean wash bucket. Top it off with pressurized water to create a rich foam and apply only to a cool surface. Keep the surface wet until fully rinsed.

For Foam Cannon - add 2 to 3 ounces of Lone Star Suds into the foam cannon and fill with water. For extra thick foam, add 2 to 3 more ounces into the foam cannon.

Rinse your vehicle well, paying attention to wheels, wheel wells and the lower portions so that you lessen the chance of picking up any grit. Start washing your vehicle from the top going down, saving the lower and potential gritty portions and wheels for last. Use a wash mitt, car mop or soft brush to apply soap on the vehicle surface with agitation to break up any stubborn grime. Leave an extra thick layer of suds to soak on the front grill, bumper and hood to help dissolve any bugs, then come back to that area to scrub after giving any bugs stains a chance to dissolve. 

Immediately rinse with water to remove the loose dirt, grime and filth along with all remaining soap. Do not let the soap dry on the vehicle by keeping it wet. If you do get any drying, reapply soap to that area. After thoroughly rinsing, wipe your vehicle down with a clean soft microfiber towel. Blow drying, especially in seams and gaps, helps prevent water spots and drips.

Once finished, flip the dispensing cap closed so the product doesn't leak or dry out.

Now for the legal stuff: Short answer - don't eat it, drink it or rub it on your naked body. Here is the required answer: